Shorelandr SLB46TBBL V.1 User Manual download pdf (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003554

Page 6

Tire Size and Carrying Capacity Chart

Tire Size ....................... ST185/80R 13C

GVWR .......................... 5920 lb.

Carrying Capacity ....... 4600 lb.

Axle .............................. Disc Brakes

Refer to the tire side wall for correct tire pressure.

ROCKER ARMS

Locate the rocker arms (Ref. No. 6 of Detail A in Diagram D. Note

that the center bushing has a grease zerk in it. Position the rocker

arms up into the center channel welded in the center of the tandem

spring bracket so that the grease zerk is pointing down. Align the

holes in the channel with the rocker arm. Secure in place with a 3/4”

x 4-1/2” hex bolt and lock nut. Tighten. Repeat this process on the

other rocker arm and spring bracket. Grease the rocker at this time

by applying grease through the zerk just discussed.

NOTE: The grease zerk is positioned down so that it is accesible

for servicing when needed.

SPRINGS

Position the axles so they are properly aligned with the trailer.

Position the brake axle so that the disc brake calipers are on the

back side of the axle. The brake axle must always be mounted as

the rear axle to give you the best braking possible (See Diagram

D. There is no right and left to the axle without brakes. It can be

mounted either way.

Place the springs on the topside of the spring pads welded to the

axle. (See chassis diagram). Note that the hook end of the spring

must be to the rear of the trailer. Place a spring clamp on the top

center of the spring as shown. Next place the 1/2” x 6-1/2” U-bolts

down over the top of the spring clamp, spring and axle as shown.

Diagram D

1 2 3 4 5 6 7 8 9 10

No comments

Shorelandr SLB46TBBL V.1 User Manual Page 6