Shorelandr SLB34BLW User Manual download pdf (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003441

Page 9

Tire Size and Carrying Capacity Chart

Tire Size ....................... ST205/75R 15-D

GVWR .......................... 4240 lb.

Carrying Capacity ....... 3400 lb.

Axle .............................. Disc Brakes

Refer to the tire side wall for correct tire pressure.

SPRINGS

Position the axle so it is properly aligned with the trailer and

the brake calipers are located on the back side of the axle.

(See Diagram D).

Place the springs on the top side of the spring pads welded

to the axle. (See chassis Diagram D). Note that the hook

end of the spring must be mounted to the rear of the trailer.

Place a spring clamp on the top center of the spring as

shown. Next place the 1/2” x 6-1/2” U-bolts down over the

top of the spring clamp, spring and axle as shown.

Place the spring and axle U-bolt plate onto the ends of the

two U-bolts just installed. Secure in place with 1/2” lock nuts.

Thread onto the U-bolts but do not tighten securely until the

complete unit is in position on the trailer. Repeat on the other

spring.

AXLE

Place one of the spring bracket bushings into the rear of the

spring bracket and secure with a 9/16” x 3 1/4” hex bolt and

hex lock nut.Repeat in other spring bracket.

Position the axle under the frame, then hook the loop end of

the spring around the bushings just installed. Note that if the

axle is positioned too low when trying to hook, the loops will

not hook around the bushings.

Raise the front of the springs up so they align with the front

hole of the spring bracket. Secure in place with 9/16” x 3-

1/4” hex bolts and lock nuts.

Tighten all axle U-bolts and spring bolts not tightened at this

time.

ONE AXLE BRAKE INSTALLATION

Cut the tape securing the brake line hose to the axle. Re-

move the brass plug from the port in the brass block on the

right brake caliper. Thread in the male end of the brake hose

and tighten to 6-8 ft. lb. or else 72-96 in. lb. of torque.

DO NOT OVER TIGHTEN. Over tightening will cause the

brass block to crack and then leak.

Place the other end of the hose through the hole in the brake

line clip bracket and secure with the U-shaped hose clip pro-

vided.

1 2 3 4 5 6 7 8 9 10

SLB34BLW 1
Diagram D 8

Comments to this Manuals

No comments

Shorelandr SLB34BLW User Manual Page 9

Comments to this Manuals

Related products and manuals for Trailers Shorelandr SLB34BLW