Shorelandr SL60TAL V.1 User Manual download pdf (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003354

REV C 4/28/06

Page 5

Diagram E

Tongue:

Fasten the tongue in the rear at the front cross member location with a 1/2”

X 4-1/2” stainless steel hex bolt and 1/2” stainless steel ﬂat washers under

the bolt head and the 1/2” stainless steel lock nut with nylon insert. Move

the tongue up to the lower frame plate of the frame. Line up the holes,

fasten the tongue in the frame with two (2) 1/2” X 3-9/16” X 5” stainless

steel square u-bolts, 1/2” beveled aluminum washers, 1/2” stainless steel

washers and 1/2” stainless steel hex lock nut with nylon inserts at the front

of the tongue plates; Refer to Detail E and F. Connect the tongue brake-

line to the sideframe with a brakeline coupling (Ref.#30 on page 4).

Safety Chain:

Mount the safety chains to the front on the tongue using a 1/2” X 1-1/2” stain-

less steel hex bolt (Ref#4) with a 1/2” stainless steel ﬂat washer at the head of

the bolt, followed by a safety chain through the drop tongue tube and secure

with a 1/2” stainless steel hex locknut with nylon insert. Repeat on other side.

Refer to Diagram E.

Wiring:

Plug in the tongue wire harness to the side frame wire harnesses located on

the ﬁrst crossmember. Pull the wire out the hole in the tongue with either the

brown and yellow or brown and green plug.

White Ground Wire Installation:

The white ground wire must be grounded to the trailer frame with a 1/4” X

3/4” stainless steel self grounding tap screw.

Attach the ground wire to the main frame by

driving the screw into the bottom ﬂange of

the side frame. This will assure a positive

ground for the lighting.

Brake line:

Place one end of the tongue brake line into

the hole in the top of the tongue located just

behind the front joint of the two side frames.

Insert until the end of the line comes out the

front of the tongue. Place the actuator into

it’s approximate location on the tongue.

Remove the plastic plug in the rear of the

actuator and thread the brake line into

the port.Tighten. Place the actuator in it’s

proper location by aligning the holes in

the mounting channel with the holes in

the tongue.

Actuator:

Mount the actuator (Item #10) to the drop

tongue section using three (3) 1/2” X 4-1/2”

stainless steel hex bolts (Item #3) and 1/2”

stainless steel hex lock nuts with nylon

inserts.

Place a grommet around the brakeline

where it comes out of the top of the tongue

to keep it from vibrating and chafﬁng as it is

being towed. Form the remaining end of the

brake line so it will mate up with the brake

line running down the side frame. Secure the

two lines together with the brass coupling

provided in Hardware box 66801. Tighten

securely to prevent leaks but do not over

tighten causing the threads in the ﬁtting to

strip.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Shorelandr SL60TAL V.1 User Manual Page 5

Comments to this Manuals

Related products and manuals for Trailers Shorelandr SL60TAL V.1