Shorelandr B30BLW User Manual download pdf (Page 10)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003432

Page 10 REV A 9/25/06

B-SERIES BUNK ASSEMBLY

Locate the two 2 x 6 bunk assemblies. Note that the bunk

mounting brackets are assembled to the bunks at the fac-

tory. Place the end with the two brackets towards the rear of

the trailer. Place the assembly on the equiload bunk arm and

secure by placing a 3/8” x 1” hex bolt through the bracket on

the bunk and the ear on the end of the equiload arm. Secure

in place using a 3/8” lock nut. Repeat on the other end of the

arm. (See Diagram A).

Place the other end of the bunk in the bracket installed on the

front cross member. Note that this bracket is not attached to

the bunk because the trailer can be adjusted to two different

lengths. Once the proper position for the rear crossmember

is determined, the front of the bunk can now be attached to

the bracket using two- No. 10 x 1-1/4” self tapping screws as

shown in Detail B.

The 3/8” x 1” bolts attaching the bunks to the equiload arms

and front bunk bracket can be tightened but not over tight-

ened.

The bunks must be allowed to rotate slightly to conform to

the boat bottom once the boat is set on the

trailer.

1 2 ... 5 6 7 8 9 10 11 12

No comments

Shorelandr B30BLW User Manual Page 10