Shorelandr PT2555TABBP User Manual download pdf (Page 3)

SIDE MARKER LIGHTS FOR TONGUE

Note: When installing the tongue in the trailer,

the side marker lights will have to be mounted to

the tongue. They are shipped in a bag that is

attached to the tongue. Insert the wire harness

from the side marker light into the larger hole in

the side of the tongue, then route the wire

harness to the rear of the tongue. Attach the

bezel with the rivets provided. Plug the side

marker light into the two female ends of the wire

harness just pulled through on the large side

hole. Snap the light assembly into the bezel.

Repeat on the other side marker light.

Secure the tongue into the frame by placing a

1/2” x 4” cross bolt in the front of the tongue

channel. Locate the tongue cover plate. Feed

the wire harness and brake line if applicable

through the hole in the tongue cover plate.

Position the tongue cover plate so the mounting

hole aligns with the hole in the rear bottom of

the tongue. Place a 1/2” x 1 1/2” hex bolt

downward through the tongue cover plate,

tongue and tongue channel. Secure both

mounting bolts with 1/2 flange lock nuts.

Tighten.

Plug the tongue wire harness ends into the

frame harnesses by matching colors and ends.

Push the excess wire provided into the rear of

the tongue or else remove the grommet in the

side frame and place the excess wire in the side

frame. Replace grommet just removed.

SAFETY CHAINS

Insert a 1/2” x 5” hex bolt through a 1/2” flat washer and then into the end link of one safety chain.

Insert the bolt into the open hole in the actuator and tongue and out the other side. Place the end link of

other safety chain then a 1/2” flat washer on the bolt and secure with a 1/2” flange lock nut. Tighten.

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004356

Page 3 of 10 4/08/2011

1 2 3 4 5 6 7 8 9 10

No comments

Shorelandr PT2555TABBP User Manual Page 3