Shorelandr LURE22LTSH V.1 User Manual download pdf (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004035

Page 9

REV B 08/09/2011

SPRINGS

Positions the axle so that it is aligned with the trailer.

Place the springs on the top side of the spring pads welded to the

axle. (See chassis) The hook end of the spring must be mounted

to the rear of the trailer. Place a spring clamp on the top center of

the spring. Place the 1/2” X 6-1/2” U-bolts over the top of the spring

clamp, spring and axle. Place the spring and axle U-bolt plate onto the

ends of the two U-bolts. Secure in place with 1/2” lock nuts. Tighten.

AXLE

Place a spring bracket bushing (Ref.#6) into the rear of the spring

bracket and secure with a 9/16” x 3-1/4” hex bolt and hex lock nut.

Repeat in the other spring bracket. Position the axle under the frame,

hook the hook loop of the spring around the bushings just installed.

Note: If the axle is positioned too low, the hooks will not hook around the

bushings.

Raise the front of the springs up so they align with the front hole of

the spring bracket. Secure in place with 9/16” X 3-1/4” hex bolts and

lock nuts. Tighten all axle U-bolts and spring bolts.

TIRE & WHEEL ASSEMBLY

Mount the tire and wheel assemblies using the 1/2” ne threaded ta-

pered lug nuts provided. Tighten to 85-95 ft./lb. of torque using the ro-

tation pattern as shown in the ShoreLandr’s Owners Manual.

Re-torque the lug nuts after 50 miles of driving and then

periodically thereafter.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Shorelandr LURE22LTSH V.1 User Manual Page 9