Shorelandr 2x5 User Manual download pdf (Page 10)

Remove the small parts from the frame by cutting the

bands. Remove the bolt bag and sort all nuts and bolts by

size.

Tongue:

Slide the tongue into the frame cap of the frame. Line up

the holes and fasten the tongue in the side of the frame

cap with a 1/2 X 4-1/4 hex bolt and 1/2 flange lock nut.

Fasten the tongue in the rear of the frame cap with a 1/2 X

1-1/2 hex bolt and 1/2 hex lock nut. Plug the tongue

harness into the frame harness, use grommets to secure

the wires in the wire holes.

Actuator & Safety Chain:

Slide the actuator into the actuator housing unit and secure

with two (2) pins and snap rings provided with the actuator.

Secure the actuator-housing unit to the front of the tongue

using three (3) 1/2 X 4 hex bolts and 1/2 flange lock

nuts. Using a 1/2 X 5 hex bolt on the lower right mounting

hole on the tongue, secure the safety chain. Place a 1/2

flat washer on the 1/2 X 5 hex bolt followed by one (1)

safety chain and insert into the actuator housing unit and

the tongue. Place a second safety chain on the bolt

followed by a 1/2 flat washer and 1/2 flange lock nut.

Roller Assembly:

Mount the 66212-- (12-roller-rack arm) assembly on the

rear pivot in a desired location that best fits your boat.

Secure this assembly by using a 1/2 X 4 carriage bolt

and a 1/2 flange lock nut. Repeat on opposite side.

Final Assembly Instructions

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Shorelandr 2x5 User Manual Page 10